• Aux@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    10 months ago

    While it might be cheaper, it’s rarely possible. Different countries have different frequencies and other stuff, so you still need to make different SKUs for different markets.

    • bamboo@lemm.ee
      link
      fedilink
      English
      arrow-up
      4
      ·
      10 months ago

      That used to be the case, but most phones now use radios that can support necessary frequencies and protocols globally. It’s also helped that the network side has also been more standardized compared to the 3g days.

        • bamboo@lemm.ee
          link
          fedilink
          English
          arrow-up
          1
          ·
          10 months ago

          As far as I can tell it’s just the C band frequency range, and radios supporting either generally support both.

          • Aux@lemmy.world
            link
            fedilink
            English
            arrow-up
            1
            ·
            10 months ago

            Many manufacturers released their phones without mmWave antennas outside of the US. Like iPhone 13 or Pixel 6.

            • bamboo@lemm.ee
              link
              fedilink
              English
              arrow-up
              2
              arrow-down
              1
              ·
              10 months ago

              Even in the US, only some high end phones support mmWave. It’s never required for service as the few areas covered by mmWave also have low or mid band 5g coverage too.

    • Ghostalmedia@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      10 months ago

      True. It basically means the connector component will be universal. Which will lower the manufacturing cost of it.

      That said, it also means that the 1st party and third party peripheral market will be universal. It would be a nightmare if companies like Anker and Belkin had to make two of every damn peripheral.